Showing all 13 results
#8-32 nylon lock nut (also referred to as a nylock).
Used in countless playfield applications on virtually every pinball machine ever built.
Sold in a pack of ten
240-5005-00 zinc plated 6-32 stopnut
4406-01119-00 zinc plated 6-32 stopnut
This is the 30 piece white rubber ring set for Alvin G & Co Al’s Garage Band Goes on a World Tour pinball machine.
The kit includes ball shooter tip, red flipper rubbers,white “O” ring rubbers
This Kit also includes a playfield placement rubber diagram. And a rubber sizing chart
Coil – flipper Alvin G (weak)
Dual wound flipper coil with sleeve and diode for Alvin G pinball machines.
C-clip or E Clip for 1/4 inch shaft –
C-clip or E Clip for 3/8 in shaft –
C-clip or E Clip for 5/16 in shaft –
C-clip or E Clip for 3/8 in shaft – ball shooter rod
C-Clip (C clip retaining clip) for most ball shooter rods.
Replaced by E clip.
Pop bumper skirt – Black
Black pop bumper skirt, or wafer, used in most pinball manufacturers’ pop bumper assemblies.
Red pop bumper skirt, or wafer, used in most pinball manufacturers’ pop bumper assemblies.
Reference No: 03-6035-4
White pop bumper skirt, or wafer, used in most pinball manufacturers’ pop bumper assemblies.
Common playfield post fastener stud with un-threaded top and wood screw bottom. 1-7/8 inch overall length.
Used with acorn post speed nut. The speed nut forms a thread on the post when installed.
Machine screw with #8-32 threads on the top side and #6-32 threads on the other side
Williams part no 02-9899
Stern Part no:530-5008-00